Pneumatic strapping tool-fault and troubleshoot

  Due to the wear work parts, screw loosening air pressure reducing reason,pneumatic steel strapping tool failure, therefore must be ruled out in time, make the machine can normally work smoothly, the cause of the fault has the following several aspects.
  1, in the pneumatic strip packing machine motor and cylinder body and all transmission, rotating parts, each class before use, must be lubricated with oil, the amount of the other, should be filled with 22# gas wheel oil regularly, quantitative in oiler in oil supply, in order to maintain a fixed, when the pneumatic steel strapping tool'motor work from the oiler, lower drop of oil is 40 - 60 drops/min best.
  2, compressed air does not match the 0.4 - 0.6Mpa, must give the adjustment, otherwise, too low pressure will affect the binding quality, high pressure can make the machine wear too fast.